silverrlude

don't plan on getting subs. Might pick up a amp for the speakers if needed put won't till i get other stuff done that is needed.

for the front:
Eclipse 8062- 6-1/2" Driver with 3/4" Silk Dome Tweeters & Crossover
Continuous Power Handling: 85W
Music Power Handling: 170W
Frequency Response: 50Hz-22kHz, ± 3dB
PentaCone
Wide-Dispersion Curvilinear Cone
6-Leg Cast Magnesium Basket
Butyl Rubber Surround
Mica-Filled Polypropylene Cone (MFP)
Neodymium Magnet
Vented Aluminum Voice Coil Former
Driver-Specific Crossover Network
Butterworth 12dB per Octave High Pass/Low Pass Filters
Mounting Depth: 2-7/8"

for the Rear:
Eclipse 89640 - 6-1/2" Point Source

Continuous Power Handling: 50W
Music Power Handling: 100W
Frequency Response: 90Hz-20kHz
Concentrically Mounted, Efficiency-Matched Components
Butyl Rubber Surround
Mica-Filled Polypropylene Cone (MFP)
Kapton Voice Coil Former
3/4" Ferro-Fluid Cooled Neodymium Silk Dome Tweeter
Model-Specific Computer-Optimized Outboard Crossover
Tweeter Protection Circuit
Alminum Power Handling Tweeter Post
Mounting Depth: 2-1/8"

__________________
.:the more rice the better:.

chrisho

yeah you'll most definitely need an amplifier. i'm assuming you have an aftermarket headunit, but even those won't be able to handle the RMS of your speakers.

i've heard the eclipse 8062s and they're pretty nice. i didn't end up going with those though, instead i went with focal 136ks. but those eclipses are still great. good luck

__________________
2000 SH - Crystal Blue Metallic - Mugen Equipped - Gone...

soopaswoze!

I run the 8062s off of a Soundsstream 700sx...

But I have Mbquart rears, I could care less about rear fill, cant here it over my sub anyway

__________________
-Mike!
IM: FlowFX / Email: mikej_skool@hotmail.com
92 Si, wit stuff, REDONE!