|
quick list of things you need to do:
-have a pair of projectors, bulbs, and ballasts that work
-you might wanna have another car to use while your headlights are being worked on, or have an extra pair of headlights you can put in.
-remove your bumper, then your headlights.
-prepare headlights by removing bulbs and all removable pieces of rubber and the 5 metal clips around the headlight.
-put 1 headlight in an oven between 250-300 F for about 6 minutes to soften/melt the glue.
-pry the clear plastic lens from the black housing. The glue in my headlights was very tacky and stretched quite a bit before it separated.
-back the low beam reflector out by turning the aiming screws the small bolt as well. Takes a long time.
-you can either mount your projector in your reflector or create a metal plate that you can mount the projector to and reuse the brackets that hold the original reflector so that the aiming screws can still be used. I used the latter method.
-make sure everything fits inside of the headlight before putting it back into the oven to remelt the glue.
that is a very basic list of things you need to do. if you need more information just post a message in this thread.
__________________
94' VTEC
|