Damnit, check out these plots:
At 80 PSI empty tank today:
At 80 PSI full tank today:
Why am I getting leaner with 80 PSI now? :-(
I noticed 3 things today..
1)I checked my static FP, the pressure was lower at first. I then pulled the vacuum hose, and it read 77 (This was after I set it bcak to 80), a few seconds later it read 80... Bad FPR??
2)I went to set my VTEC lower (from 4500 -> 3800) on my V-AFC, I then monitored the engagement point.. it didn't say VTi-ON until I hit well over 4000RPM (Is it supposed to say "On" right away?)
3)My first 3 speeds for the heater/ac have dissapeared.. It only works on HI (Even kicks in the A/C on the lower speeds, but no blower.
If anyone could give me any direction, it would be appreciated...